Budget-friendly high-roof MPV/van built on the Logan platform in Tangier, Morocco, and sold with this diesel in Germany from 2012 to 2020. The sliding rear doors and 800-litre cargo area made it popular with families and small businesses across Europe and North Africa. Available as a five-seat passenger Dokker, raised Stepway, and two-seat Dokker Van. The dCi 75 and 90 use a 5-speed gearbox; the Blue dCi 75 and 95 from September 2018 use a 6-speed.· more· less
Proven K9K diesel, cheap partsVery low purchase and running costs
DPF and EGR need regular highway useBelow-average build and paint quality
Buy if: You need a spacious, economical diesel van with sliding doors and can verify regular servicing including timing belt history.
Avoid if: You mostly drive short urban trips (DPF will clog) or the service history is incomplete or missing.
Price & maintenance
Used price
€8,000
median asking price, typically 115,000 km
Typical range€6,000 – €13,000
Maintenance cost
€650 – €1,250/year
at 15,000 km/year
Fixed costsservice, tyres, brakes€450 – €750 /yr
Risk bufferunplanned repairs€200 – €500 /yr
Price estimates are based on German asking prices. Prices and costs vary by vehicle condition and location.
Ownership costs
Maintenance assumes 15,000 km a year. Price estimates are based on German asking prices. Prices and costs vary by vehicle condition and location.
Used price
€8,000
Typically €6,000 – €13,000, at around 115,000 km.
Maintenance
€650 – €1,250per year
€450 – €750
service, tyres, brakes
€200 – €500
repair buffer
Price & maintenance
Used price
€11,000
median asking price, typically 115,000 km
Typical range€7,900 – €13,000
Kilometres drivenAll
Maintenance cost
€650 – €1,250/year
at 15,000 km/year
Fixed costsservice, tyres, brakes€450 – €750 /yr
Risk bufferunplanned repairs€200 – €500 /yr
Price estimates are based on French asking prices. Prices and costs vary by vehicle condition and location.
Ownership costs
Maintenance assumes 15,000 km a year. Price estimates are based on French asking prices. Prices and costs vary by vehicle condition and location.
All dCi and Blue dCi variants: turbo fails from oil starvation or carbon buildup in the oil feed line · more· less
The K9K uses a small Garrett or BorgWarner turbocharger that is generally reliable when oil changes are performed on schedule. Failure is accelerated by extended oil change intervals, incorrect oil specification, or shutting off the engine immediately after sustained high-speed driving without a brief cool-down idle. Carbon residue accumulates in the oil feed line and starves the turbo bearings. Symptoms include blue or white exhaust smoke, loss of power, and whistling noises. A reconditioned exchange turbo fitted at an independent garage costs around €600-900. A new OEM turbo installed runs €1,000-1,500. Regular oil changes every 20,000 km or 12 months, sooner for short trips, with the correct Renault-approved specification oil are essential for turbo longevity.
Fuel injector degradation
up to €1,8002 of 7
All dCi and Blue dCi variants: common rail injectors clog or leak, especially after 120,000 km on lower-quality fuel · more· less
The K9K common rail injectors (supplied by Delphi on earlier engines, Siemens/Continental on later variants) are a known weak point across the K9K family. Symptoms include metallic knocking at idle, black exhaust smoke, diesel smell from leaking copper sealing washers, and increased fuel consumption. A single injector replacement costs around €200-400 including labour. If all four injectors plus the fuel pressure regulator need replacing, costs can reach €1,500-1,800. Remanufactured injectors offer a cheaper alternative at around €100-150 each. Using quality diesel and changing the fuel filter on schedule (every 20,000 km) significantly extends injector life.
DPF clogging from short-trip driving
up to €1,2003 of 7
All dCi and Blue dCi variants: diesel particulate filter blocks if the car rarely reaches sustained motorway speeds · more· less
All Dokker 1.5 dCi models have a DPF (Euro 5 minimum). The filter requires sustained driving above 2,500 rpm for 15-20 minutes to trigger automatic regeneration and burn off accumulated soot. Cars used primarily for short urban trips will not reach the necessary exhaust temperatures. When the DPF warning light appears, a forced regeneration at a workshop costs around €100-150. Professional DPF cleaning runs €200-350. If the filter is fully blocked beyond recovery, replacement costs €600-1,200 depending on whether an aftermarket or OEM unit is used. Dokkers used as commercial vehicles with regular longer routes are much less affected.
EGR valve clogging
up to €4504 of 7
All dCi and Blue dCi variants: exhaust gas recirculation valve accumulates carbon, causing rough idle and power loss · more· less
The EGR valve on the K9K engine builds up sticky carbon residue over time, particularly on cars driven for short trips or in urban conditions where the engine rarely reaches full operating temperature. Symptoms include rough idle, hesitation under acceleration, and the engine management warning light. Chemical cleaning at a specialist costs €100-200 and can restore full function if caught early. Once the EGR actuator seizes, replacement costs €250-450 fitted. Some owners report that periodic sustained high-RPM motorway driving helps keep the valve cleaner.
Sliding door mechanism wear
up to €5005 of 7
All variants: sliding door rollers, latches, and striker plates wear with use, causing rattling and difficulty closing · more· less
The Dokker's rear sliding doors use roller guides and a latch mechanism that wears over time, particularly on frequently used passenger and commercial vehicles. Symptoms include a door that does not latch firmly, rattling while driving, a door-ajar warning light, and increasing force needed to open or close. Roller and guide replacement costs €100-250 per door including labour. A complete latch mechanism replacement runs €200-350 per side. Regular lubrication of the roller tracks and striker plates with silicone-based grease helps extend the mechanism's lifespan.
AdBlue/SCR system malfunction
up to €8006 of 7
Blue dCi only (from 2018): NOx sensor, SCR pump, or AdBlue injector failure triggers limp mode · more· less
Blue dCi variants (75 and 95 PS, from 2018) use selective catalytic reduction with AdBlue injection to meet Euro 6 emissions standards. The system includes an AdBlue tank, pump, injector, and NOx sensors. Common failures include the AdBlue heater in cold weather, crystallised fluid clogging the injector, and NOx sensor degradation. Symptoms include a warning message, reduced engine power, and eventually limp mode with a countdown to engine shutdown. Individual component replacement costs €150-400. A full AdBlue pump and sensor replacement can reach €600-800. Using good-quality AdBlue and not running the tank empty helps prevent pump damage. This issue does not affect pre-2018 dCi variants without the SCR system.
Front suspension and steering joint wear
up to €5007 of 7
All variants: ball joints and tie rod ends wear faster than average; TÜV inspections flag steering-joint defects notably more often from about nine years · more· less
German TÜV and other European roadworthiness inspections flag worn suspension and steering components on older Dokkers, including front ball joints, tie rod ends, and anti-roll bar links. The budget-level components and the vehicle's higher kerb weight compared to a Sandero or Logan contribute to faster wear, particularly on poor road surfaces. Symptoms include clunking over bumps, imprecise steering, and uneven tyre wear. Ball joint or tie rod end replacement costs €100-200 per side including labour. A full refresh of front suspension joints and anti-roll bar links costs €300-500. TÜV results show early inspections are largely unremarkable, while steering-joint defects become notably more frequent at around nine years.
Proven K9K diesel with typical emissions-related weak points
The K9K 1.5 dCi is one of the most widely produced diesel engines in Europe, and the Dokker's simple construction keeps repair costs low when issues do arise. The main ownership risks are diesel-specific (DPF clogging, EGR fouling, injector wear, turbo failure) and are largely preventable with regular highway driving and timely oil changes every 20,000 km or 12 months, sooner for short trips. Sliding door mechanisms require periodic attention and lubrication. Budget-level paint quality means surface corrosion is common but rarely structural. Blue dCi variants (from 2018) add AdBlue system complexity.
Service history
Complete Dacia dealer or specialist records essential. Verify oil changes every 20,000 km or 12 months, sooner for short trips. Check timing belt replacement proof.
Tires
Check tread depth, age (date codes on sidewall), and look for uneven inner-edge wear indicating worn suspension joints.
Cold start
Start the engine completely cold. Listen for any metallic knocking or excessive rattling in the first 30 seconds.
Test drive
Drive for at least 20 minutes including varied speeds. Watch for warning lights, particularly DPF and engine management.
Specific for this vehicle
Listen for injector knock at idle
With engine warm and idling, listen for irregular metallic ticking. Some ticking is normal for a diesel, but loud or uneven knocking suggests worn injectors.
Check DPF warning history
Ask the seller about DPF regeneration warnings. If the car has been used mainly for short trips, the DPF may be partially clogged. A diagnostic scan can show soot loading percentage.
Test both sliding doors thoroughly
Open and close both rear sliding doors several times. Check that they latch firmly, open smoothly on the roller guides, and that the door-ajar light goes off when closed.
+ 4 more checksShow less
Inspect wheel arches, sills, and door edges for rust
The Dokker's thin paintwork bubbles early, especially around wheel arches, door latch cutouts, and sill edges. Surface rust is cosmetic but indicates poor protection.
Verify timing belt replacement
The K9K requires a timing belt and water pump change every 120,000 km or 6 years. Ask for proof of replacement. If overdue, budget €450-820.
Check AdBlue system on Blue dCi variants
Blue dCi models (from 2018) have an AdBlue tank and SCR system. Check for AdBlue warning messages, and verify the tank level. Crystallisation around the filler cap suggests neglect.
Check front suspension for play
With the car on a lift, check front ball joints and tie rod ends for excessive play. Clunking over bumps or a wandering steering feel during the test drive indicates worn joints.
Recalls and Technical Service Bulletins
Rear seat backrest may loosen (EU Safety Gate A12/0766/14), vehicles built 13 June 2013 to 24 January 2014Verify completed
Sliding door lock may fail in a side impact (EU Safety Gate A12/0148/17 and A12/0552/17), vehicles built 3 July 2015 to 11 October 2016Verify completed
Track rods may break and steering may fail (EU Safety Gate A12/0026/16), vehicles built 17 September to 4 December 2015Critical - verify completed
ABS/ESC hydraulic unit contamination (EU Safety Gate A12/0956/16), vehicles built from 26 February 2016 whose hydraulic unit was assembled 12 February to 3 March or 17 March to 12 April 2016Verify with VIN
Catalytic converter weld defect allowing an exhaust gas leak (EU Safety Gate A12/2022/18, Dacia code 0D0E), vehicles built 1 March to 7 April 2018Verify completed
Driver airbag may not deploy correctly (EU Safety Gate A12/1254/19 and A12/0087/19, Dacia codes 0D06 / 0COO), vehicles built 4 April to 28 August 2018Critical - verify completed
Contact a Dacia dealer with the VIN to verify all recalls have been completed. The sliding door lock recall (A12/0148/17, A12/0552/17), the track rod recall (A12/0026/16) and the driver airbag recall (A12/1254/19, A12/0087/19) are particularly important safety items. All recalls have limited build windows, so most Dokkers are unaffected, but verification is essential.
Warranty Status
Factory warranty, Dacia Germany (3 years / 100,000 km)Expired on all Dokker 1.5 dCi models
Perforation warranty, Dacia Germany (6 years from first registration)Conditional on unbroken manufacturer servicing and corrosion inspections
In Germany, Dacia offered a 3-year / 100,000 km factory warranty and a 6-year anti-perforation body warranty from first registration, subject to adherence to the manufacturer's service schedule and anti-corrosion inspections recorded in the service booklet. All Dokker models are now outside their original factory warranty. The perforation warranty covers rust-through holes in body panels only, not surface corrosion or paint defects.
Sources: Research draws on model-specific owner forums and owner communities, recall information from official authorities, German automotive press, and multiple workshop cost references cross-checked against each other.
This report is for informational purposes only and does not constitute professional advice. Estimates may be inaccurate. Always have a qualified specialist inspect the vehicle before purchase. We accept no liability for decisions made based on this information.